Lamp
When current flows through the lamp, an optical signal is activated. In FluidSIM, the lamp is colored with the set color.
Adjustable parameters
| Designation | Range | Default value |
|---|---|---|
| Rated voltage | 0.1 ... 400 V | 230 |
| Rated power | 0.1 ... 10000 W | 50 |
Failure models
| Failure model | Description |
|---|---|
| Filament blown | No current flows because the lamp has blown. |
| Short circuit | The lamp causes a short circuit. |
| Faulty voltage value | The nominal voltage specified in the failure configuration is used. This may lead to an unexpected flow of current. |
| Faulty power value | The nominal power specified in the failure configuration is used. This may lead to an unexpected flow of current. |
| Poor contact | An additional serial resistance specified in the failure configuration is used, in order to simulate an excessive resistance for example. |
| Residual current via PE port | The 'p' connector is connected to the 'pe' connector via the 'Rrc_err' resistor. |
| Designation | Range | Default value |
|---|---|---|
| Rated voltage | 0.1 ... 400 V | 30 |
| Rated power | 0.1 ... 10000 W | 1 |
| Resistance in series | 0.001 ... 1000 Ohm | 50 |
| Resistance for residual current | 0.0001 ... 1000 Ohm | 1 |